Pride Quantum 610 Series Owner's Manual page 19

V . C O M F O R T A D J U S T M E N T S
Power Elevating Seat (Optional)
If your power chair is equipped with a power elevating seat,
you can change the seat height either through the controller
or through a toggle switch mounted to one of the armrests.
To change the seat height through toggle switch:
1. Press forward on the toggle switch to raise the seat. See
figure 20.
2. Pull back on the toggle switch to lower the seat.
WARNING! Do not allow the motor to run
more than
mechanism reaches the top or bottom limit.
NOTE: For more information on operating the power ele-
vating seat through the controller, contact your Quantum
Rehab Provider.
WARNING! The power elevating seat option is intended for use on a level surface only. Never
raise the seat from its lowest position on an inclined surface. Failure to heed this warning can
result in the power chair tipping over.
WARNING! Never raise the seat from its lowest position when operating your power chair on
bumpy or uneven surfaces. Failure to heed this warning can result in the power chair tipping
over.
WARNING! Never raise the power elevating seat while your power chair is in the freewheel
mode.
WARNING! Always fasten the positioning belt when operating the power elevating seat.
NOTE: The power elevating seat option is equipped with a system that reduces the speed of the power chair by
one half when the seat is elevated more than 1-2 inches (2.54-5.08 cm). Always check to be sure this system is
operating properly before using your power chair.
Quantum 610 Series
a few seconds after
www.pridemobility.com
the
Figure 20. Power Seat Toggle Switch
19