Controller Position - Pride Quantum Rehab edge Owner's Manual

V . C O M F O R T A D J U S T M E N T S

Controller Position

You can move the controller in toward or out away
from the armrest, or change the position of the control-
ler for either left-hand or right-hand use.
MANDATORY!
harness damage! Avoid routing the
controller harness on the outside of
the armrest pad. Route the harness
under the armrest or toward the inside
of the armrest pad. Use correct tie-
down points for the controller harness
to prevent the harness from getting
caught in the drive tires, pinched in
the seat frame, or damaged when
passing through doorways.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector from the front of
the power base. See figure 3.
3. Remove any wire ties securing the controller har-
ness to the armrest.
4. Loosen the adjustment knob on the armrest where
the controller is currently located. See figure 17.
5. Relocate the controller to the desired armrest and
tighten the adjustment knob to secure the control-
ler.
6. Use wire ties to secure the controller harness to the
armrest.
7. Route the controller harness to the front of the
power base and reconnect the controller. See fig-
ure 18.
NOTE: If your power chair is equipped with a power
positioning system, refer to the information provided
in supplemental manuals provided with your seating
system.
Q6 Edge
Prevent controller
www.pridemobility.com
Figure 17. Controller Position
Figure 18. Cable Routing
19