Reset to Default
Reboot System
LED Light OFF/ON
Upgrade Fir mw are
To reset the camera to factory default, click "Apply". Then, follow
the instruction of the screen to complete the process. The factory
defaults are as follow s.
Camera Name: "WIPCamera_MJPEG"
IP Address: "192.168.2.3"
Subnet Mask: 255.255.255.0
Administrator Name: "Admin", Passw ord: "1234"
Video Port: "4321", Web Port: "80"
To reboot the Internet Camera, click " Reboot System" and click
"Apply".
There are four LEDs to indicate the status of Internet Camera. If
you w an to secure the camera from noticing, you can turn off the
LED light by clicking "LED Light OFF" and click "Apply". To turn
on the LED light, click "LED Light ON" and click "Apply".
Click "Upgrade Fir mw are" and "Apply" buttons the Web
Management w ill lead you to enter into upgrade mode. Select the
"*.bin" file and click " Upgrade" to start upgrading. Note that the
Internet Camera w ill stay in Upgrade Mode until you finish the
firmw are upgrading.
49