Power Supply Wiring - Extron electronics MTP DA4 User Manual

NOTES:
d
Output Mute connections — The Output Mute connector provides a way to mute
(blank) any or all TP outputs. Each numbered pin of the captive screw connector is
assigned to one of the DA outputs. Pin A is assigned to all DA outputs (see figure 4).
When you short and latch a numbered pin or pins to ground, the DA mutes the
associated outputs.
Output Mute Connector
1 2 3 4 5 6 7 8 A
Output Mute Connector
Figure 4.

Power Supply Wiring

Figure 5 shows how to wire the power connector (see the caution, attention, and notes on
the next page before wiring the power connector).
Tie Wrap
(5 mm) Max.
Smooth
A
Power Supply
Output Cord
Figure 5.
• The MTP DA output does not provide any pre-peaking control. The total
recommended distance for a complex system with multiple DA outputs is
the same as for a simple system with a single transmitter and receiver.
• See the recommended transmission ranges in the table on page 2. The
recommendations in the table apply to a complete transmission system,
which can include a single transmitter, DA, and multiple receivers or a
complex system including multiple daisy-chained receivers.
Pin
1
MTP DA8
2
3
4
5
6
MTP DA4
7
8
A
1 2 3 4 A
Mute Connector and Pinout
2-Pole Captive Screw
Connector
SECTION A–A
3/16"
Ridges
A
Power Connector Wiring
MTP DA4 and MTP DA8 • Installation and Operation
Contact
Function
Closure
Out #1 Mute output #1
Out #2 Mute output #2
Out #3 Mute output #3
Out #4 Mute output #4
Out #5 Mute output #5
Out #6 Mute output #6
Out #7 Mute output #7
Out #8 Mute output #8
Out All Mute all outputs
Gnd Ground
7