Installation And Operation; Connections - Extron electronics MTP DA4 User Manual

Installation and
Operation
This section provides information pertaining to the installation and operation of the
MTP DA4 and MTP DA8, including:
•
•
•
•
•

Connections

ATTENTION: Do not connect these devices to a computer data or telecommunications
MTP DA8
MTP DA4
Figure 3.
a
b
c
Connections
Power Supply Wiring
TP Cable Termination
Front Panel Power Indicator
Skew Delay Problems
network.
A/V OUTPUTS
A/V INPUT
1 2 3 4 5
POWER
12V
0.93A MAX
1 2 3
A/V INPUT
1
POWER
12V
0.93A MAX
1 2
MTP DA Rear Panel Features
Power connector — Plug the included external 12 VDC power supply into this 2-pole
captive screw connector (see
AV Input connector — Connect one end of the cable carrying the video or
audio/ serial TP link from the transmitting device to this RJ-45 female connector (see
TP Cable Termination
on page 8 to wire the RJ-45 connectors).
AV Output connector — Connect one end of up to four or eight TP cables to these
RJ-45 female connectors.
Connect the free ends of the same cables carrying the distributed video or audio/serial
TP link to the RJ-45 connectors on the receivers (see
to wire the RJ-45 connectors).
6 7 8
OUTPUT MUTE
1 2 3 4 5 6 7 8 A
4
A/V OUTPUTS
2 3 4
OUTPUT MUTE
1 2 3 4 A
3 4
Power Supply Wiring on page 7 to wire the connector).
TP Cable Termination
MTP DA4 and MTP DA8 • Installation and Operation
on page 8
6