Termination And Mute Jumpering - Mtp 15Hd Systems Only - Extron electronics MTP DA4 User Manual

Twisted pair distribution amplifiers
Hide thumbs Also See for MTP DA4:
Table of Contents

Advertisement

Termination and Mute Jumpering —
MTP 15HD Systems Only
NOTE:
When an MTP T 15HD A or SW MTP T 15HD A provides the input, the MTP DA output can
include analog audio as well as RGB video. When an MTP T 15HD RS provides the input, the
DA output can include a serial (RS-232) link as well as RGB video.
A jumper block inside the MTP DA sets the DA to properly terminate the audio or serial
portion of the input signal when the input signal is transmitted by an MTP 15HD A series
(audio), SW MTP T (audio), or MTP 15HD RS series (serial) transmitter.
A second jumper block sets the DA to mute the audio or serial link when its video mute
function is activated. The DA can also be set to always pass the audio or serial link regardless
of the contact closure mute status.
By default, the MTP DA is configured with the internal jumpers set to terminate audio
(default). For serial data applications, the DA can be configured to properly terminate the
signal as follows:
1.
2.
3.
The position of jumpers J3 and J9 have no effect when the DA is installed as a
part of an MTP SV series or VTT001/VTR001 system.
If applicable, disconnect all cables, remove the DA from its installation location, and
remove any mounting brackets installed (see
Remove the two screws from both sides of the DA and the two screws on the top (six
screws total) and lift the top cover off of the DA (see figure 2).
Select audio or serial distribution — Locate jumper J3 on the main board and
shift the jumper from the audio (default, on the right) to the serial (left) position (see
figure 2).
Serial
or
Audio
(Default)
J3
Jumper Block J3
Inside Box
Remove 6 screws,
lift top straight up.
Figure 2.
Opening the DA and Termination Jumpering
Mounting
on page 14).
Disable
Enable
or
Mute
Mute
(Default)
J9
Jumper Block J9
Inside Box
T E
M U
U T
T P
O U
A
8
7
6
5
8
4
3
2
7
1
6
S
U T
T P
5
O U
A /V
4
3
2
1
T
P U
IN
A /V
R
W E
P O
X
V
M A
1 2
3 A
0 .9
MTP DA4 and MTP DA8 • Introduction
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mtp da8

Table of Contents