Select The Required Options; Interrupting A Programme; Programme Has Started; At The End Of The Programme - Electrolux EWS 1030 Instruction Booklet

7. Select the required options

The light corresponding to the depressed button
illuminates.
+
8. Select the DELAY START option
To delay starting of a programme, press the DELAY
START button. The figures corresponding to the
selected delay will be displayed for about 3 seconds,
after which the duration of the selected programme
will appear on the display.
During this period it is possible to load other laundry:
• depress START/PAUSE button;
• load the laundry;
• close the door and depress START/PAUSE button
again.

9. Start the programme

To start the selected programme, press the
START/PAUSE button; the corresponding light stops
flashing.
The pilot light corresponding to the wash phase
which is running is on.
The machine starts operating.
If you have selected the delayed start the machine
starts its countdown. The display shows the delay or
the duration of the programme.
10. Changing an option or a programme
during its cycle
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button.
Changing a running programme is possible only by
resetting it.
Turn the programme selector dial to O and then to
the new programme position. The washing water in
the tub will not emptied out. Start the new
programme by depressing the START/PAUSE
button.

11. Interrupting a programme

Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding
light starts to flash. Depress the same button again
to restart the programme.
12. Opening the door after the

programme has started

First set the machine to PAUSE by pressing the
START/PAUSE button.
If the door does not open, this means that the machine
is already heating, that the water level is above the
bottom edge of the door or that the drum is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by depressing the
ON/OFF button. After about 3 minutes the door can
be opened (pay attention to the water level and
temperature!). To restart the programme depress
ON/OFF button again after closing the door.

13. At the end of the programme

The machine stops automatically.
If the Rinse hold
remains blocked, the light of the START/PAUSE
button goes off, the pilot lights
to indicate that the water must be emptied out before
opening the door. The display shows a flashing zero.
Turn the programme selector dial to Reset O and
press ON/OFF button to switch the machine off .
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
16
has been selected the porthole
and remain lit,