Exiting Service Mode; Service Menus; Verifying Service Data Changes; Resetting Wega (User) Menu To Factory Defaults - Sony KDF-46E2000 Service Manual

SERVICE MENUS

(CATEGORIES ONLY)
TV MICRO TV MICRO (cont.)
VERSION IRIS_DBC
ID IRIS_ADJ
NVM_SEL IRIS_UFOFS
MODEL IRIS_WBOFS
OSD IRIS_SCSB
CCD IRIS_FIXED
CCT DSP_STEP
OPTIONS DSP_SURR
CXA2229Q DSP_MIXR
USER_NR DSP_AGC
LPF_1 DSP_BT
SNNR DSP_BBE
SNSS DSP_DRC
CCPM_1 DSP_BQ
CCPM_2 FAN_CTRL
CCPM_3 TEMP_SRV
CCPM_4 TEMP_BRTO
CCPM_5 PAWN_3DG
CCPM_6 PAWN_SYS
CCPM_7 PAWN_CAP
CCPM_8 PAWN_MUT
CCPM_9 PAWN_PIC
CCPM_10 PAWN_BLK
CCPM_11 PAWN_WBO
CCPM_12 PAWN_TSP
PAWN_CUR
HELIOS_1
HELIOS_2 PAWN_TIM
HELIOS_3 PAWN_HPF
IRIS_APL
HELIOS_4
HELIOS_5 TIME
SCREEN IMG_SHIFT
DCP_INT HDMI
DCP_OSD
DCP_BLK
DCP_ADJ1
DCP_ADJ2
DCP_USER
DCP_AVP
A7001R
A7001G
A7001B
A7007R
A7007G
A7007B
A7007RGB
KDF-46E2000/46E2010/50E2000/50E2010/55E2000/55E2010

2-4-1. EXITING SERVICE MODE

After completing the changes, exit service mode by turning off the set
using the Remote Commander or the power switch.
Q BOX
QM
NOTE: After exiting service mode wait 2 minutes before restarting
QT
the set to allow the fans to shut down properly.

2-5. VERIFYING SERVICE DATA CHANGES

1. After completing all adjustments turn the set off with the Remote
Commander and WAIT for the fans to turn off before proceeding to
the next step.
Note: It may take up to two minutes for the fans to stop.
Caution: To avoid over heating the lamp, do not unplug the set
until the fans have stopped.
2. After the fans have stopped, unplug the set from the AC outlet, then
plug the set back in the AC outlet.
3. To verify the changes repeat steps 1 through 3 of 2-4. Using the
Remote Commander to Change Service Data.
4. To exit service mode, turn the power off by pressing POWER .
Wait 2 minutes before restarting the set to allow the fans to
completely shut down or the Service Menu will appear on the screen.
NOTE: After exiting service mode wait 2 minutes before restarting
the set to allow the fans to shut down properly.
2-6. RESETTING WEGA (USER) MENU TO
Use the following instructions to restore the User Controls and
Channel Memory settings to the preset factory conditions.
1. Turn the TV on by press POWER on the Remote Commander.
2. While holding down the
POWER button on the Front Panel of the set.
The set restarts and displays the initial setup screen. This may take
several minutes.
KDF-46E2000/46E2010/50E2000/50E2010/55E2000/55E2010
FACTORY DEFAULTS
on the Remote Commander, press the
51