Options - Lennox AQUALEAN AWC Application Manual

GENERAL CHARACTERISTICS

1.11.- OPTIONS

HEATING OPTIONS
ELECTRICAL HEATERS. (UNITS 007 to 020).
ACW
007 008
AWH
Standard 2
Medium 5
High
HEATING MODE AWH
AWH 007 008
Standard 2
INSTALLATION
Electrical heater is assembled in the
unit.
Supply sensor is delivered outside
the unit and it should be installed in
the duct using the sheet metal fi xation
delivered with the unit.
See picture below for the installation.
CONTROL OPTIONS (ALL UNITS).
ModBus / BACNET / LONWORKS COMMUNICATION
The control board is equipped with a RS485 serial communication port to
allow remote management through communication bus.
According to the wished communication protocol, our control board can be
fi tted with ModBUS®, LonWorks® or BacNET® communication interface.
DS60 (Service display)
This display provides access to the full controler menu to set all parameters.
24V customer display located at 30 meters maximum from the unit. Remote customer parameter reading and
modifi cation.
DM60 display for scheduling and zoning.
it is possible to enable up to 7 time zone per day with 4 different operating modes for each of the zone. This can be
done with the DM60 or during commissioning by a Lennox certifi ed technician.
• 18 •
COOLING MODE
010 012 015
3 (1F-3F)
5(1F-3F)
9 (3F)
010 012 015
3 (1F-3F)
018 020
5
9
12
Electrical heater
018 020
5
3 5 0
Service
Display
AQUALEAN - AWC/AWH - MIL118E-1407 / 10-2013