Horizontal Air Terminal Installation; Extended Horizontal And Corner Air Terminal Installation - Napoleon GD19N Installation And Operating Instructions Manual

4.3.1 HORIZONTAL AIR TERMINAL INSTALLATION

Move the appliance into position.
A.
Measure the vent length required
between terminal and appliance
taking into account the additional
length needed for the fi nished
wall surface and any 1¼" overlaps
between venting components.
Apply high temperature sealant W573-
B.
0007 (not supplied) to the outer edge of the
inner collar of the appliance. Attach the fi rst
inner rigid pipe component and secure using 3 self
tapping screws. Repeat using the outer rigid pipe.
Insert the vent pipes through the fi restop maintaining the required
C.
clearance to combustibles. Holding the air terminal (lettering in an upright,
readable position), secure to the exterior wall and make weather tight by sealing with caulking (not
supplied).
The air terminal mounting plate may be recessed into the exterior wall or siding no greater than the
depth of the return fl ange.

4.3.2 EXTENDED HORIZONTAL AND CORNER AIR TERMINAL INSTALLATION

A. Follow the instructions for "HORIZONTAL AIR TERMINAL INSTALLATIONS" section.
Continue adding components alternating inner rigid pipe and outer rigid pipe. Ensure
B.
that all inner rigid pipe and elbows have sufficient vent spacers attached and each
component is sealed and securely fastened to the one prior. Attach the inner telescopic
sleeve to the vent run. Repeat using the outer telescopic sleeve. Seal and secure as
before. To facilitate completion, attach inner and outer couplers to the air terminal.
C. Install the air terminal. See "HORIZONTAL AIR TERMINAL INSTALLATION" section.
#10x2"
SCREWS
CAULKING
INNER
RIGID
OUTER
PIPE
RIGID
PIPE
2" OVERLAP
HI-TEMP
SEALANT
26.3
AIR TERMINAL
20"
VENTING
48.1
27
TELESCOPIC
SLEEVE
W415-1004 / B / 08.10.12