Troubleshooting - JVC NX-SA1B Instructions Manual

Compact component system
Table of Contents

Advertisement

Available languages

Available languages

References

Troubleshooting

If you are having a problem with your System,
check this list for a possible solution before
calling for service.
General
Power does not come on.
\ Check the power cord connection.
The System turns off automatically.
\ Auto power save function (A.P.S.) is working.
Adjustments or settings are suddenly
canceled before you finish.
\ There is a time limit. Repeat the procedure.
Unable to operate the System from the
remote control.
\ The path between the remote control and
the remote sensor on the System is blocked.
\ The battery is exhausted.
No sound is heard.
\ Adjust the volume.
\ Headphones are connected.
iPod operations
iPod does not play.
\ The battery of iPod is low or exhausted.
Charge the battery of iPod.
USB device operations
The USB device does not play.
\ The USB device is not connected properly.
MP3/WMA groups and tracks are not played
back as you expect.
\ Playing order was determined when the
groups and tracks are recorded. It depends
on the writing application.
The USB device sound is discontinuous.
\ MP3/WMA files have not been properly
copied onto the USB device.
\ Noise and static electricity may stop the sound.
In this case, disconnect and connect the USB
device again after turning off the System.
22
FM radio operations
Hard to listen to broadcasts because of
noise.
\ Antenna connection is incorrect or loose.
\ The FM antenna is not properly extended
and positioned.
\ Electrostatic discharge from your body may
cause noise. If this happens, turn the System
off then on again.
Timer operations
The Sleep Timer does not work.
\ The Daily Timer is working. The Sleep Timer
can not be set when the Daily Timer is
working.
The Daily Timer does not work.
\ The System is turned on when the on-time
comes. The Daily Timer starts working only
when the System is turned off.
If the System does not work correctly after
these procedures...
The System works using a built-in
microprocessor. If buttons are not operative,
disconnect the AC power cord from the wall
outlet, wait for a while, then connect the cord
again.
JVC bears no responsibility for any loss of
data on iPod or the USB mass storage class
device while using this System.

Advertisement

Table of Contents
loading

Table of Contents