Specifications - Jacuzzi Finestra FL61000 Installation & Operation Instructions

Important: Read complete instructions before beginning installation.
Each whirlpool bath arrives ready for installation, completely equipped with motor/pump assembly, heater, plumbing, and fittings
necessary for whirlpool operation. A rotary drain/overflow kit is provided for installation on the bath, and an optional remote drain/
overflow assembly is also available.
Remove the bath from the carton. Retain the shipping carton until satisfactory inspection of the product has been made. Do not lift
the bath by the plumbing at any time; handle by the shell only or the aluminum handles provided at the ends of the unit.
Immediately upon receipt, inspect the shell before installing. Should inspection reveal any damage or defect in the finish, do not
install the bath. Damage or defect to the finish claimed after the bath is installed is excluded from the warranty. Jacuzzi Whirlpool
Bath's responsibility for shipping damage ceases upon delivery of the products in good order to the carrier. Refer any claims for
damage to the carrier. For definitions of warranty coverage and limitations, refer to the published warranty information packed with
the product.
All bath units are factory tested for proper operation and watertight connections prior to shipping.
note: Prior to installation, the bath must be filled with water and operated to check for leaks that may have resulted from shipping
damage or mishandling. Jacuzzi Whirlpool Bath is not responsible for any defect that could have been discovered, repaired, or
avoided by following this inspection and testing procedure.

sPeCiFiCations

lH=left Hand, rH=right Hand
16-3/4"
29-1/2"
BACK
Model Dimensions
Finestra™ 6030 60" (1524 mm) L
30" (762 mm) W
LH, RH
38-1/2" (952.5) H
Finestra™ 6036 60" (1524 mm) L
36" (914 mm) W
LH, RH
38-1/2" (952.5) H
11-11/16"
* Add 1/4" to this dimension when roughing-in for 3-wall niche.
For all Units: Electrical Service Requirements: All require a dedicated GFCI protected separate circuit ( See page 7 to 12).
note: 1. Measurements inside each unit represent cutout in floor to allow for drain/overflow.
2. All measurements are in inches. To convert to millimeters, multiply inches by 25.4.
3. Service access dimensions given are minimum size.
4. The overall dimensions are nominal with a tolerance of +0 and -1/4" (6.4 mm).
Jacuzzi Whirlpool Bath: finestra Walk-in Bath
sPeCiFiCations
13-3/4"
Service
Access
6-1/2"
LEFT END
Drain/Overflow
Dimensions Cutout
15" (381 mm) A See
below
11-11/16" (297 mm) B
18" (457 mm) A See
below
11-11/16" (297 mm) B
A
DRAIN/OVERFLOW
L
17-1/2"
Service Access
FRONT
total Weight/Floor operating
loading gallonage
1038 lb (472 kg), 55 gal (208 liter) min,
41.5 lb/ft (202 kg/m ) 75 gal (284 liter) max
2 2
1177 lb (535 kg), 55 gal (208 liter) min,
47.1 lb/ft (229 kg/m ) 85 gal (321 liter) max
2 2
B
Page 
2"
W
H
14"
1-1/2"
RIGHT END
Product skirt/
Weight Mounting
See pages Integral
6 to 11
See pages Integral
6 to 11
11-11/16"
fl61000B • 10/07
Heater
Factory
installed
Factory
installed