Page of 28

Jacuzzi Finestra FL61000 Installation / Operation Instructions Manual: Suction/intake Cover/strainer Maintenance

Jacuzzi walk-in bath installation/operation instructions.
MaintenanCe

suction/intake Cover/strainer Maintenance

Clean the suction/intake cover/strainer of hair and debris
when necessary. To do this, remove the center screw and
detach the square cover. Clean the cover by backflushing
debris from the holes. Replace the suction/intake cover
immediately after cleaning. Be careful not to overtighten the
screw. When reinstalling, orient the cover/strainer with the
small notch at the bottom. The gasket must be inserted into
the groove of the cover/strainer before reinstalling onto the
suction fitting.
CaUtion: keep hair a minimum of 6 inches (15.2 cm) away
from the suction/intake fitting at all times when the whirlpool
system is operating. Hair longer than shoulder length should
be secured close to the head, or a bathing cap should be
worn. Do not operate the whirlpool system with the suction/
intake cover removed! It is a safety device and must always
be in place on the suction fitting to minimize the potential
hazard of hair and/or body entrapment.
interconnection of airbath, Whirlpool, and
salon Baths
The interconnection of the airbath, whirlpool bath, and salon
bath is shown in the following figures.
Jacuzzi Whirlpool Bath: finestra Walk-in Bath
SUCTION COVER/STRAINER ASSEMBLY
COVER STRAINER
SCREW
NOTCH
Page 20
SUCTION
FITTING
GASKET
fl61000B • 10/07

   Related Manuals for Jacuzzi Finestra FL61000

   Related Content for Jacuzzi Finestra FL61000

Comments to this Manuals

Symbols: 0
Latest comments: