ZXR10 8900 Series Hardware Installation Manual
F
44 R
IGURE
EINSTALLATION THE
F
45 C
IGURE
ONNECTION
1.
Six screws M8×12
2.
Spring washer
3.
Flat washer
50
Confidential and Proprietary Information of ZTE CORPORATION
A
S
NGLE
UPPORT
4. Between two near cabinets, use six screws M8×12, flat washer,
spring washer and M8 nut to connect angle support. The in-
stallation of two near cabinets is shown in
B
T
N
C
ETWEEN
WO
EAR
4.
Angle support
5.
M8 nut
5. After connecting the cabinets, fix the cabinet. If the cabinet is
installed by an adjustable base, press the footing with pressure
plate. Fix the pressure plate on adjustable base with M12×30
screws. As a result, the footings are fixed. If the cabinet is
installed on floor directly, press the footing with pressure plate,
and fix the pressure plate on expansion bolt on floor. As a
result, the cabinet is fixed.
6. Install cabinets orderly according to step 5. Fix all footings.
7. Inspect the support condition of each footing.
Result: The cabinets have been connected.
ABINETS
Figure
45.