Dispensers – Removal & Installation - Bosch SHI4302 Manual

VI. Component Access/Replacement
VI. Component Access/Replacement
Dispensers
Dispensers
To remove/install dispensers:
Remove outer door, remove fascia panel & disconnect wire harness
from fascia panel.
Disconnect wire harness from above dispenser, then remove wires
to wax motor & reed switch.
Disconnect condensation tube (for older models with condensation
tubes in doors).
Bend retainer tabs, the push dispenser inward toward tank. Protect
hand with towel as edges are sharp.
Replace from inside of tank -- position O-ring seal and bend tabs to
secure. When replacing dispensers, lubricate O-rings with rinse-aid
& support inner doors to avoid damage if O-rings stick.
Disconnecting wire harness
– Removal & Installation (1)
– Removal & Installation (1)
CAUTION: Inner door edges are
sharp! Cover door edges and
remove dispenser carefully.
Bending retainer tabs
53