Circulation Pumps - Reassembly; To Remove & Install Impeller - Bosch SHI4302 Manual

VI. Component Access/Replacement
VI. Component Access/Replacement
Circulation Pumps
Circulation Pumps
To remove & install impeller (using kit # 167085)
To remove & install impeller (using kit # 167085)
While holding motor fan so shaft won't spin (1a), unscrew impeller
counterclockwise (1b).
Rotate pump housing counterclockwise until tabs clear, then lift
housing from motor (2).
Remove spring and O-ring from pump housing, then lift spacer up
from motor shaft (3).
Place replacement spacer onto motor shaft (4). Note larger end
goes onto shaft 1st.
Install replacement spring & O-ring onto pump housing, then line up
housing-motor tabs to screw pump housing onto motor (5a). Screw
replacement impeller onto motor shaft (5b).
Align motor to pump housing with capacitor @ 11:00 position to
facilitate reassembly.
- Reassembly
- Reassembly
Motor fan
1a
2
37
:
:
1b
3
5a 5b
4