Xm4400 Control Panel - Xyron XM4400 Instruction Manual

XM4400 Control Panel

Control panel – Top View
The control panel for the XM4400 is located on the right hand side of the machine. The following
paragraphs review each of the controls.
Auto / Foot
The Auto/Foot Switch changes the motor control modes. Auto mode allows the motor
to run constantly. Foot mode allows you to start and stop the machine by pressing and
releasing the foot pedal, allowing for greater control. Foot mode is the default.
Forward / Reverse
The Forward/Reverse Switch changes the motor direction. During normal operation
the machine should always be switched to "forward" mode. The main reason for using
the "reverse" setting would be to remove an installed roll of material.
Emergency Stop Button
The Emergency Stop Button will immediately stop the machine if pressed. To release
the emergency stop, twist it clockwise. The emergency stop button will override all
other switches including the ON/OFF switch.
Power Button
The Power Button is the main power switch. The XM4400 can only be operated when
the button has been depressed and the indicator lamp is lit. To turn machine off,
depress the power button again and the indicator light will turn off.
Control panel - Front View
11