Hoshizaki DCM-60KE Service Manual page 29

17) Wait for 10 minutes. During this time, use a clean cloth and some of the remaining
solution to wipe the inside of the storage bin and the bin cover. (Do not fit the agitator or
the drip ring.)
18) Refit the storage bin cover, and loosely fit the machine's top panel.
19) Plug in the ice dispenser to make ice with the sanitising solution.
20) With the water supply tap open, move the ice making switch to the "ON" position. Allow
the machine to continue ice making for a further 20 minutes.
21) Move the ice making switch to the "OFF" position.
22) Press the drain switch on the control panel.
23) While the display illuminates "DRAIN" during the 1 minute drain cycle, pour clean warm
water carefully into the bin to melt any ice and into the opening in the center to an
overflow level. Be careful not to wet the bin control switch on the storage bin cover.
24) Unplug the ice dispenser.
25) Remove the top panel and storage bin cover.
26) Remove the agitator by unscrewing counterclockwise. Lift out the drip ring.
27) Take a clean cloth and a pan of fresh cold water to wipe/rinse thoroughly the bin liner
and storage bin cover.
28) Wash the agitator and drip ring with a neutral cleaner. Rinse thoroughly.
29) Immerse the agitator and drip ring into the remaining sanitising solution. Rinse
thoroughly.
30) Refit the removed parts in reverse order.
26