Kenwood Nexedge NX-200G Instruction Manual page 22

■ Making Individual Calls (Digital)
If a key has been programmed with [Individual] or
[Individual + Status], you can make calls to specifi c
persons.
1 Press the key programmed as [Individual] or
[Individual + Status].
2 Press
• On keypad models, you can enter a unit ID directly.
3 Press and hold the PTT switch to make the call.
• Speak into the transceiver as you would during a normal
transmission.
RECEIVING
Select the desired zone and channel. If signaling has been
programmed on the selected channel, you will hear a call only
if the received signal matches your transceiver settings.
Note: Signaling allows your transceiver to code your calls. This will
prevent you from listening to unwanted calls. Refer to "SIGNALING"
{page 27} for details.
■ Receiving Group Calls (Digital)
When you receive a group call on a Conventional channel
and the received group ID matches the ID set up on your
transceiver, you can hear the caller's voice.
When on a Trunking channel, if the Group ID of a received
call matches your Group ID, you will hear the call.
■ Receiving Individual Calls (Digital)
When you receive an individual call, a ringing tone will
sound and the caller's ID will appear on the display.
To respond to the call, press and hold the PTT switch and
speak into the transceiver as you would during a normal
transmission.
12
/ to select a unit ID from the list.