Table of Contents
Advertisement
between these two. If you do not need to set too much
pitch shift amount, set this parameter to Slow. If you
wish to change the pitch significantly, use Fast.
HighDamp
Sets the damping amount in the high range.
Trim
Sets the input level.
27. GrainSft
S.GrnSft
This effect samples extremely brief fragments of the
[000...100%]
sound at a specified interval, and plays them as a loop.
This is effective when used on external input sounds
that are constantly changing.
[000...127]
If used for an insert effect, this will be mono-in/mono-
out.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Right
If used for the master effect, this will be stereo-in/ste-
reo-out.
Stereo In - Stereo Out
Left
Right
BPM Sync (Duration BPM Sync)
Specifies whether playback of the looped waveform will
be synchronized. If this is On, the looped waveform will
play in synchronization with the tempo or MIDI clock.
TimRatio (Time Ratio)
This specifies the length of the looped waveform rela-
tive to the "Duration" value.
Duration
Sets the duration of the grain. The length of the wave-
form is determined by this setting and the "TimRatio"
setting.
If "BPM Sync" is Off, this is set in msec units.
If "BPM Sync" is On, this is set as a timing resolution rel-
ative to the tempo specified by the [TEMPO] knob or
MIDI clock.
If you use this in an insert effect and the other in-
sert effect uses a delay or chorus effect, the wave-
form length will be limited.
If the "Duration" and "TimRatio" settings exceed
the limit, an indication of OVER will appear for
the "TimRatio."
Effect parameters
: IFX
(Grain Shifter)
(Stereo Grain Shifter)
+
Grain Shifter
Sample Cycle
LFO
Grain Shifter
Sample Cycle
Grain Shifter
Sample Cycle
LFO Spread
LFO
[BPM Sync Off: 000.5...400.0% (OVER)
BPM Sync On: 012.5...400.0% (OVER)]
[BPM Sync Off IFX: 000...500msec
BPM Sync Off MFX: 000...350msec
BPM Sync On 1/64...1/1]
: MFX
Dry / Wet
Dry / Wet
Dry / Wet
Dry / Wet
[Off, On]
23
Advertisement
Table of Contents
