Operation; General; Checks Before Starting - Ferris HydroCut Series Operator's Manual

Note: The further a handle is moved away from the
neutral position the faster the mower will travel.
These handles also deactivate the engine kill system
when depressed. Release the handles to activate
the engine kill system. The engine will shut off if the
operator releases the handles with the PTO engaged
or parking brake disengaged.
Engine Kill / Operator Presence
Handles
These handles are a major factor in the safety
interlock system of the mower. Both handles are
tied together so depressing one handle depresses
both. The operator must depress the handles in order
to deactivate the engine kill system. Handles must
be depressed to disengage the parking brake and
engage the PTO switch.
GENERAL OPERATING SAFETY
Before first time operation:
• Be sure to read all information in the Safety and
Operation sections before attempting to operate
this tractor and mower.
• Become familiar with all of the controls and how to
stop the unit.
• Drive in an open area without mowing to become
accustomed to the unit.

CHECKS BEFORE STARTING

• Check that crankcase is filled to full mark on
dipstick. See the engine Operator's Manual for
instructions and oil recommendations.
• Make sure all nuts, bolts, screws and pins are in
place and tight.
• Fill the fuel tank with fresh fuel. Refer to engine
manual for fuel recommendations.
• Make sure fuel shut off valve is in the ON position.
WARNING
Before leaving the operator's position for any
reason, disengage the PTO, stop the engine
and remove the key.
To reduce fire hazard, keep the engine, tractor
and mower free of grass, leaves and excess
grease. Do not stop or park tractor over dry
leaves, grass or combustible materials.
Gasoline is highly flammable and must be
handled with care. Never fill the tank when the
engine is still hot from recent operation. Do not
allow open flame, smoking or matches in the
area. Avoid over-filling and wipe up any spills.
WARNING
Select slow ground speed before driving onto
a slope. Use extra caution when operating on
slopes.
Mow up and down the face of slopes, not
across, use caution when changing directions
and DO NOT START OR STOP ON SLOPE.
WARNING
If you do not understand how a specific control
functions, or have not yet thoroughly read the
FEATURES & CONTROLS section, do so now.
Do NOT attempt to operate the tractor without
first becoming familiar with the location and
function of ALL controls.

Operation

13