Table of Contents
Advertisement
For your own safety, do not connect the machine to the power source until the machine is completely
assembled and you read and understand the entire instruction manual.
ATTACHING THE MITER SAW ARM TO THE BASE
DISCONNECT MACHINE FROM POWER SOURCE!
1.
Align the bevel lock handle screw (A) Fig. 2 on the miter saw
arm with the bevel hub (B) on the base.
2.
Thread the bevel lock handle screw (A) Fig. 2 into the bevel
hub (B) by turning the bevel handle knob (K) Fig. 3.
ATTACHING THE BEVEL POINTER
DISCONNECT MACHINE FROM POWER SOURCE!
1.
Loosen the bevel lock handle (K) Fig. 3, and tilt the miter saw
arm to the 45 degree position.
2.
Align the hole in the bevel pointer (C) Fig. 3 with the hole (D)
in the back of the base.
3.
Insert the M5x.8x10mm pan head screw with washer (B)
Fig. 3 through the hole in the bevel pointer (C). Thread the
screw into the hole (D) in the back of the base and tighten
securely.
NOTE: To adjust the pointer, see the section "ADJUSTING 90
°
AND 45
BEVEL STOPS".
ATTACHING THE TABLE LOCK HANDLE
Thread the table lock handle (A) Fig. 4 into the threaded hole (B)
of the arm bracket.
ROTATING THE TABLE TO THE 90° DEGREE POSITION
1.
Turn the table lock handle (A) Fig. 5 counter-clockwise one
or two turns, and depress the index lever (B) to release the
45° positive stop.
B
Fig. 2
C
B
°
Fig. 3
A
Fig. 4
Fig. 5
9
A
D
K
B
K
B
A
Hide quick links:
Advertisement
Table of Contents
