Time And Date - Planet NVR-401 User Manual

3. Enable "DHCP Server" under "DHCP Server" if you wish to use the recorder
as a DHCP server, o
the network
4. Click Apply for the settings to take effect.
The recorder can detect the presence of a DHCP server upon startup. It
sets itself to use static IP address if there is no DHCP server currently
presented in the network. Its DHCP server function is also turned on at the
same time to assign IP addresses to cameras that are later connected to the
network. You can manually turn off the DHCP server function if you wish to use
a separate DHCP server.
Change the recorder's IP address would require the recorder to restart.
Restart the device under "system Options" >> "Maintenance" for the settings to
take effect.

6.1.2 Time and Date

Set the time and date by selecting the time
is imperative that you set th
e rrors:
• Incorrect display time for playback videos.
• Inconsistent display time of even
Af ter selecting the time zone, choose an option below to set the recorder time.
• Manual - Use the drop-down lis
• Sync with NTP server
server and set how often the recorder should synchronize the time with the
r ecorder by using the "Update interval" drop-down menu.
• S ync with PC - Check this option to synchronize the recorder time with the
PC that you are currently using to access the recorder.
r leave it disabled if there is already a DHCP server in
.
e recorder's time correctly to avoid the following
t logs and when they actually occur.
t and configure the time manually.
- enter the hostname or IP address of a valid NTP
zone according to your location. It