Blower Service Or Replacement (1101); Blower Service Or Replacement (1402) - Napoleon EPI 1101 Installation And Operating Instructions Manual

7.9

BLOWER SERVICE OR REPLACEMENT (1101)

A. Turn off all electrical power to the appliance. Remove the glass door and set
aside in a safe place.
B. Remove the top right side bricks from inside the fi rebox, 4-#7's and 2-#2's. Then
remove the rest of the side and back bricks from the right side of the appliance.
It is not necessary to remove the bottom bricks.
C. The access panel can be removed by taking out the 8 #10 self taping screws.
A 5/16" nut driver will be required to complete this job. Unplug wires from the
thermal switch on the panel.
D. Remove the securing wing nut from the blower mounting bracket, slide the
bracket to the right and rotate the left side of the assembly out of the cav-
ity to clear the blower motor. Disconnect the two wires from
the blower motor. Remove the ground wire from the blower
mounting bracket, then the assembly can be taken out of the
rear cavity through the access door opening.
E. Remove the 3 screws that hold the blower to the mounting
bracket. Service or replace the blower as required.
F. Reinstall the blower assembly making sure the blower bracket
is seated under the securing tab. Reattach the wire connec-
tors.
G. Replace the gasket on the access door. To replace the access
panel, reverse Step C.
H. Replace the bricks into the fi rebox. Reinstall the door.

7.10 BLOWER SERVICE OR REPLACEMENT (1402)

A. Turn off all electrical power to the insert.
Remove the glass door and set aside in a
safe place.
B. Remove the two screws from the outer edge
of the side panel(s).
C. Push the side panel toward the door and
pull away from the insert, releasing the
panel from the keyed slot.
D. Service or replace the blower(s) as required.
E. Re-install the side panel(s) by reversing the procedure.
GASKET
THERMAL
SWITCH
GROUND STUD
WING NUT
WIRES
BLOWER
HEAT
RHEOSTAT
BLOWER
SENSOR
W415-0764 / B / 10.28.11
25
SECURING
TAB
G
B
W