Audio Mode; Local Time Setting - Topfield SRP-2100 User Manual

You cannot fully enjoy wide-screen programmes with your
normal-screen television as the above figures show. The left
figure shows a normal picture displayed in the normal screen.
To watch wide-screen programmes in the shape like the centre
figure, set the Display Format option to Letter Box. Wide-screen
pictures then will be reduced to fit to the width of the normal
screen. Otherwise, to watch them in the shape like the right
figure, set it to Center extract. Then wide-screen pictures will
be cut out on the left and right sides equally to fit to the width
of the normal screen.

4.2.5 Audio mode

Basically, there are two audio sources as you can find two audio
sockets on the back panel of the digital receiver. You can enjoy
only one source or both of them in either stereo or mono. Set
the Sound Mode option as you desire.
Apart from this setting, you can change the sound mode with
the
The digital receiver can output two types of digital audio sig-
nals via the S/PDIF connector. One is an encoded signal, and
the other is a decoded signal. If your digital audio system does
not have a Dolby Digital decoder, you have to set the Dolby
Digital option to Off. Otherwise, set it to On.
NOTE
If the service you are currently watching does not provide
Dolby Digital, you cannot watch the programme with Dolby
Digital sound even though you set the Dolby Digital option to
On.

4.3 Local time setting

You should set your local time for timer events.
button. See § 5.2.4 for a detailed description.
4.3 Local time setting 39
4