General Troubleshooting - iRobot Cleaning System Owner's Manual

Priming scooba's Pump - Scooba's powerful cleaning system includes a pump that

distributes cleaning solution from the tank onto your floor. To prime Scooba's pump, fit the
end of the included suction bulb over Scooba's solution valve. Push air through Scooba's
pump system 3 or 4 times.

general Troubleshooting

Problem
Scooba will not
start cleaning
Excessive foam
coming out of Scooba
Cleaning head sticks
out of Scooba, will
not engage
2
iRobot Scooba Owner's Manual
Solution
Valve
likely Cause
Power is off
Battery is not charged
Battery is not correctly
seated
There is too much
cleaning solution
concentrate in Clean
tank
Cleaning head is not
closed tightly over the
brush
what To Do
Press Power, then press Clean to start
Scooba.
Charge Scooba's battery. (page 11)
Remove battery and ensure that battery
tabs are placed inside Scooba's guide
holes before closing Scooba's tank.
Empty and rinse the Clean tank thoroughly.
When re-filling, make sure to use only 1.5
ounces of Scooba cleaning solution and
to fill the Clean tank completely to the rim
with water.
With the tank open, slide the cleaning head
out of Scooba. Squeeze the cleaning head
completely closed over the brush before
re-inserting it into its proper location.
(page 18)