Related Manuals for iRobot Roomba i3
Summary of Contents for iRobot Roomba i3
- Page 1 Robot aspirateur Robot aspirador i3 / i4 Owner’s Guide Guide du propriétaire Guía del usuario...
-
Page 2: Safety Information
Safety Information Important Safety Information This owner's guide includes information for Regulatory Model(s): RVD-Y1 SAVE THESE INSTRUCTIONS WARNING: When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS WARNING: To reduce the risk of injury or damage, read and follow the safety precautions when setting up, using and maintaining your robot. - Page 3 WARNING: Indicates a hazardous situation that, if not avoided, could CAUTION result in death or serious injury. CAUTION: Indicates a hazardous situation that, if not avoided, could • Do not operate the robot in areas with exposed electrical result in minor or moderate injury. outlets in the floor.
- Page 4 BATTERY WARNING • For best results, only use the iRobot Lithium Ion Battery that comes with the robot. • Do not use non-rechargeable batteries. Use only the • Do not open, crush, heat above 176°F: 80°C, or incinerate.
-
Page 5: About Your Roomba
Spot Clean Button Dirt Disposal Edge-Sweeping Port* Brush CLEAN / Power Button Dust Bin Charging Home Button Contacts Brush Frame Release Tab Cliff Sensor Cliff Sensor Caster Wheel Floor Tracking Cliff Sensor Sensor *Select models only For more information, visit global.irobot.com... -
Page 6: Using Your Roomba
For instructions and more details *Objects are not to scale. on this Reduced Power Standby Mode, refer to the iRobot WARNING: To prevent the risk of your robot falling downstairs when it is HOME App. - Page 7 Home Base™. • When your robot detects an especially dirty area, it will go into • If you are unsure if the robot is finished or paused, consult the iRobot HOME Dirt Detect™ mode, moving over the area multiple times until App to check on its status.
- Page 8 Accessories Choose the mode to meet your needs: Virtual Wall Mode: When the switch is in the Virtual Wall position ( ), the device will create a linear barrier to block openings up to 10 feet (3 meters). Dual Mode Virtual Wall Barrier* ®...
-
Page 9: Care And Maintenance
Place bin back in the robot. Note: iRobot manufactures various replacement parts and assemblies. If you think you need a replacement part, please contact iRobot Customer Important: The robot will not run Care for more information. if the filter is not installed correctly. - Page 10 Cleaning the Full Bin Sensors Washing the Bin Cleaning the Edge-Sweeping Brush Remove and empty the bin. Use a small screwdriver to loosen the Important: Do not wash the filter. screw holding the Edge-Sweeping Remove the filter before washing the bin. Brush in place.
- Page 11 If the wheel is not with the shape of the brush icons in spinning freely after you have cleaned it, please contact the cleaning head module. Customer Care. For more information, visit global.irobot.com...
-
Page 12: Irobot Customer Care
You can start by visiting global.irobot.com for support tips, frequently asked questions and information about accessories. This information can also be found in the iRobot HOME App. If you need further assistance, call our Customer Care team at (877) 855-8593. -
Page 13: Regulatory Information
1-800-822-8837 ©2020 iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730 USA. All rights reserved iRobot, Roomba, iAdapt and Virtual Wall are registered trademarks of iRobot Corporation. Home Base and Dirt Detect are trademarks of iRobot Corporation. Wi-Fi and the Wi-Fi logo are registered trademarks of Wi-Fi Alliance.