General Troubleshooting - iRobot Scooba 300 series Owner's Manual

General Troubleshooting

Refer to the table below to resolve Scooba's problem.
Problem
Scooba will not
power on
excessive foam
coming out of
Scooba
Cleaning head sticks
out of Scooba, will
not engage
Possible Cause
Power is off
Battery is not charged
Battery is not correctly
seated
Warning Light is on
There is too much
cleaning solution
concentrate in Clean
tank
Cleaning head is not
closed tightly over the
brush
What To Do
Press Power, then press Clean to start
Scooba.
Charge Scooba's battery (see page 9).
Remove battery and ensure that battery
tabs are placed inside Scooba's guide
holes before closing Scooba's tank.
Refer to Warning Light troubleshooting
(see page 11).
empty and rinse the Clean tank
thoroughly. When re-filling, make sure to
use only 7 ml of Scooba cleaning solution
and to fill the Clean tank completely to
the rim with water.
With the tank open, slide the cleaning
head out of Scooba. Squeeze the cleaning
head completely closed over the brush
before re-inserting it into its proper
location (see page 6).
global.irobot.com 12