Fellowes Jupiter 125 Instructions Manual page 4

ENGLISH
HOT LAMINATION STEPS
1
1. Please connect the laminator to the
socket using the separate power cable
supplied.
4
3 4 5
7
4. Use navigation keys to select setting for
the hot lamination pouch thickness (3-7
mil) you wish to laminate.
7
3 4 5
7
7. "Wait" LED ( ) will stop flashing
and acoustic bleep signal will sound when
machine is ready to laminate selected pouch
thickness.
10
10. Before switching off laminator, feed
empty cleaning sheet through machine to
clean unit.
4
2
5
3 4 5
7
8
8. Place pouch, sealed edge first, into
laminator entry. Keep pouch straight and
use the edge guide to center it.
3
3 4 5
7
3. Press Stand-by button at left of front
operating panel to switch laminator on.
6
6. While laminator is warming up, please
prepare item you wish to laminate. Place the
item inside the pouch and center it against the
sealed edge of the pouch. To prevent jamming,
use a carrier sheet when item is smaller than
the pouch.
9
9. To prevent jamming, immediately remove
laminated item from back of machine. Let
item cool on flat surface for several seconds.