Recording Using The Receiver; Using The Remote; Changing Button Assignments - Sony STR-DH500 Operating Instructions Manual

Using the Remote
Changing button
assignments
You can change the factory settings of the
input buttons to suit the components in your
system. For example, if you connect a DVD
recorder to the VIDEO jacks on the receiver,
you can set the VIDEO button on this remote
to control the DVD recorder.
c:
~.
j
(Q
-
~
CD
:tJ
CD
3
o
-
C D
-
Note
You cannot change the settings of DMPORT and
TUNER buttons.
1
Hold down the input button of
which you want to change the
assignment.
Example: Hold down VIDEO.
2
Referring to the table below,
press the corresponding
button for the category you
want.
Example: Press 4.
Now you can use the VIDEO button to
control the DVD recorder.
2
Prepare the playback
component for playing.
For example, insert the video tape you
want to copy into the VCR.
3
Prepare the recording
component.
Insert a blank video tape, etc. into the
recording component (VIDEO) for
recording.
4
Start recording on the
recording component, then
start playback on the playback
component.
Notes
• Some sources contain copy guards to prevent
recording. In this case, you may not be able to
record from the source.
• You cannot record from DMPORT if you have
- connected the DMPORT video jack to the
VIDEO VIDEO IN jack on the receiver (page
50).
- assigned "DMPORT
v."
to "-VIDEO" in the
VIDEO menu (page 31).
You can record from a video component using
the receiver. Refer to the operating
instructions supplied with your recording
component.
1
Press one of the input buttons
to select the playback
component.
You can also use INPUT SELECTOR on
the receiver.
Recording using the
receiver
continued------
53 US