Connection To An Audio System - Denon DVM-1845 Operating Instructions Manual

The following shelwS examples of connections commonly used to connect the DVD player to TV and other
components.
If using this DVD player to play back a DVD in a Dolby Digital Multi channel surround or DTS surround format, the DVD
player outputs a Dolby Digital or DTS data stream from its OPTICAL or COAXIAL DIGITAL OUT jacks.
By hooking up the player to a Dolby Digital or DTS decoder, you can enjoy more convincing, realistic ambience with
powerful and high-quality surrounding sound of a professional standard which can be heard in movie theaters.
Use a commercially available audio optical or coaxial digital cable for the audio connections.
NOTES:
• Be sure to turn off the power of all components in the system before connecting another component.
• Refer to the Instruction Manuals for your TV, stereo system and any other components to be connected to the
DVD player.
~ Connection to an Audio System j
@ @
@o
I I
o@
0 0
Optical cable
(commercially
available)
DIGITAL OUT
IPCM/BITSTREAMj
I
i
loAtl
COAXIAL OPTICAL
d~
I \"",,
1
°1
D O ' 0 0
c:::::::J .........
AV amplifier with a built in decoder
(AV control center),
Dolby Digital decoder,
DTS decoder,
MD deck or OAT deck
DIGITAL OUT
Audio Coaxial
Digital cable
(commercially
available)
I
Method
21
Digital Audio Input Jacks
AUDIO
OUT
L
0>
<0
R
Stereo system
r--'=:-l
I
00
(g
I
~Ol
AUDIO OUT
(analog)
Audio cable
(supplied)
I
Method 1
I
I!!Im
Audio Input Jacks
• Method 1 DVD Player + Stereo system
• Method 2 DVD Player + AV amplifier with a built in decoder (AV control center), Dolby Digital decoder, DTS decoder, MD
deck or OAT deck
NOTES (for Method 2 only):
• When using an AV amplifier with a built in decoder (AV control center), Dolby Digital or DTS decoder as shown in the
Method 2, set DOLBY DIGITAL or DTS to BITSTREAM accordingly for audio output in the setup mode (refer to page 30).
Set it to PCM or OFF for the decoder that is not used currently. Playing back a DVD using incorrect settings may generate
noise distortion, and may also damage the speakers.
• The audio source on a disc in a Dolby Digital Multi channel surround format cannot be recorded as digital sound by an MD
deck or OAT deck.
• Set DOLBY DIGITAL to PCM and DTS to OFF for audio output in the setup mode for connecting to an MD deck or OAT deck
(refer to page 30).
• Harsh noise that could harm your ears or the speakers is generated when a DVD recorded in DTS is played while using a
decoder, etc., that is not DTS-compatible.
• When playing back a copyright-protected 96kHz PCM DVD, the digital sound will be down sampled at 48kHz, even if you set
LPCM SELECT to OFF (refer to page 30).
Optical cable (commercially available)
• Optical cable (commercially available) may be damaged when bent at sharp angles. Ensure cables are coiled in loops with
a diameter of 6 inches (15 cm) or more when storing them.
• Use a cable which is 9.8 feet (3m) or shorter.
• Insert cable plugs firmly into the connectors when making connections.
• If a plug has dust or is dirty, clean it with a soft cloth before inserting it into a connector.
-14 -
EN