Connections; Description - Rear Panel - Denon DVM-1845 Operating Instructions Manual

-<
Description - Rear Panel
"
~
~
~
o~
~o
AUDIO DIGITAL OUT COMPONENT
S·VloEo
REMOTE
o~
OUT IPttNlIlTSTREAMj
VIOEOOUT OVT
CONTROL
l Y PRICR
G
COAXIAL OPTICAL
G~
~
l i N
j~
HOM IOUT
::~
~. ~~
~H:
0
@9
G
~[Q]
GG
o
OUT
~ ~
~ R
VIOEO
PRIC. IlOOMTO
1l000A
~
OUT
i
I I
I I
I
i
I
1
2 3
4 5 6
7
1. HDMI OUT Jack
Use an HDMI connection cable (commercially available) to connect to a display with an HDMI compatible port.
2. AUDIO OUT Jacks
Connect to the Audio input jacks of AN-compatible TV or wide screen TV, Stereo system.
3. DIGITAL OUT Jacks
Use either an optical or coaxial digital cable (commercially available) to connect to an AV amplifier with a built-in
decoder (AV control center).
4. VIDEO OUT Jack
Use a video cable to connect one of the jacks to Video input on your AN-compatible TV or wide screen TV.
5.
COMPONENT VIDEO OUT Jacks
Use a Component Video cable (commercially available) to connect these jacks if you have a TV with Component Video
in jacks. These jacks provide CO/PB. CR/PR and Y video. Along with S-Video, Component Video provides the best quality
picture.
6. S-VIDEO OUT Jack
Use the S-Video cable (commercially available) to connect this jack to the S-Video jack on your AN-compatible TV or
wide screen TV for a higher quality picture.
7. REMOTE CONTROL IN/OUT Jacks
Connecting the DENON Satellite Remote Control to these jacks enables you to operate more than one DENON compo-
nents with one remote control.
When using the DENON Satellite Remote Control,
1. Connect the DENON Satellite Remote Control to the REMOTE CONTROL IN jack of this player. This allows you to oper-
ate this player with the Satellite Remote Control.
2. Connect another DENON component to the REMOTE CONTROL OUT jack of this player. This allows you to operate this
player and the connected component with the same Satellite Remote Control.
NOTE:
• When there is video output from the HDMI OUT jack, no signal is output from the COMPONENT VIDEO OUT jacks.
Selecting Progressive Scan (525p/480p or Interlaced 525i/480i) Playback
e If your TV is compatible with progressive scanning (525p/480p), connect the TV to the COMPONENT VIDEO OUT jacks of
the DVD player and set PROGRESSIVE to ON in the DISPLAY setting. Next, set your TV to the progressive scan mode.
Refer to page 29 for instructions on changing the display setting. P.SCAN will appear on the display of the unit.
elf
yourTV is not compatible with progressive scanning, set PROGRESSIVE to OFF (refer to page 29). Make sure that P.SCAN
on the display of the unit lights off.
e Use a commercially available adaptor if the video input jacks of your TV or monitor is the BNC type.
What is Progressive Scanning?
• Unlike conventional interlace scanning, the progressive scan system provides less flickering and images in higher resolution
than that of traditional (525i/480i) television signals.
Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are trademarks
of Dolby Laboratories.
"DTS" and "DTS Digital Out" are registered trademarks of DTS, Inc.
-13 - EN