Graco 6900 Series Owner's Manual page 68

Stroller

Hide thumbs Also See for 6900 Series:

Table of Contents

belt because of the upright angle at which you must pull. You may have to

unbuckle the seat belt, estimate a seat belt length that will make the seat

belt very tight, then buckle it again.

A lap/shoulder combination belt with a latchplate that can slide

freely along the belt

seat belt can be converted in another way that is described in your vehicle

owner's manual. See your vehicle owner's manual to find out if your seat

belt can be converted to prevent movement of the lap

portion of the belt. Otherwise, the locking clip MUST

be used. The locking clip will keep the lap/shoulder

belt from sliding through the latchplate.

To install the locking clip:

a. Tighten the buckled seat belt by pushing down hard on the safety seat

and pulling hard on the shoulder belt.

b. While continuing to push down on the safety

seat, let go of the shoulder belt and pinch the

shoulder and lap belts together near the latchplate.

c. While still pinching the belts together, unbuckle

the seat belt. Do not allow the belts to slip.

requires the locking clip, unless your vehicle's

inch

Table of Contents