Problem Solving; Troubleshooting - Kodak i2900 User Manual

6 Troubleshooting

Contents

Problem solving

Problem
Documents are jamming or multiple
documents are feeding
U9 (document jam) is being displayed
in the operator control panel and paper
is stopping in the transport, but is not
jamming.
The scanner will not scan/
feed documents
Image quality is poor or has decreased Make sure that the scanner and imaging guides are clean. Refer to
A-61778 December 2013
Problem solving ......................................................................................... 6-1
Indicator lights and error codes.................................................................. 6-4
Upgrading software .................................................................................... 6-4
Contacting Service ..................................................................................... 6-4
Use the chart below as a guide to check possible solutions to problems you
may encounter when using the Kodak i2900 Scanner.
Make sure that:
• all documents meet specifications for size, weight, and type, etc. as
outlined in Appendix A, Specifications.
• all staples and paper clips have been removed from the documents.
• all rollers and tires are clean and the separation roller and feed module
are properly installed. See the procedures in Chapter 5, Maintenance.
To remove a document jam:
• Remove any documents from the input tray.
• Open the scanner cover.
• Locate the jammed document(s) and remove it.
• Close the scanner cover and resume scanning.
Verify that the Document Management: Maximum Length option on the
Device-General tab (TWAIN Datasource) or the Longest Document
option on the Scanner tab (ISIS Driver) is set to longer than the longest
document being scanned. The default is 17 inches / 43.2 cm.
Make sure that:
• the power cord is plugged in and the power is on.
• the power button has been pushed on and the green LED is lit.
• the scanner cover is completely closed.
• documents are making contact with the feed module and are covering
the paper present sensor.
• documents meet specifications for size, weight, and type, etc.
• for thicker documents, turn the gap release dial vertically to open the
space between the feed module and separation module.
• you check the feed module and separation roller for signs of wear, and
replace these parts if necessary.
You can also power the scanner down and power it up again.
Chapter 5, Maintenance.
Possible Solution
6-1