Fujitsu PRIMERGY RX600 S3 Options Manual page 14

Notes on safety
Before setting up
V
ATTENTION!
During installation and before operating the device, observe the
instructions on environmental conditions for your device (see
operating manual).
If the device is brought in from a cold environment, condensation may
form both inside and on the outside of the machine.
Before operating the device, wait until it is absolutely dry and has
reached approximately the same temperature as the installation site.
Failure to observe these guidelines can lead to material damage of
the device.
Transport the device only in its original packaging or in packaging
which protects it from knocks and jolts.
Installation and operation
V
ATTENTION!
If the rack model is integrated in an installation that receives power
from an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for the non-industrial power supply networks for the
type A connector.
The server automatically adjusts to a mains voltage from 200 V - 240
V. Make sure that the local mains voltage is neither above nor below
this range.
This device has safety-tested power cables and must only be
connected to properly grounded power outlets.
Make sure that the power sockets on the device or the grounded
mains outlets are freely accessible.
The power switch does not disconnect the device from the mains
voltage. To completely disconnect it from the mains voltage, you must
remove the power plugs from the power outlet.
14 Options Guide RX600 S3
Important notes
U41640-J-Z156-2-76