Reversing The Camber Tube Mounting Bracket Direction - Invacare CROSSFIRE T6 Owners Operating & Maintenance Manual

4. Align the desires mounting positions of the camber tube mounting brackets with the
opening of the camber tube supports.
5. Install the four socket screws, washers, and lock washers into the desired mounting
positions of both camber tube mounting brackets. Hand tighten.
6. Slide the camber bar forward or backward to adjust the wheelbase length to the
desired position. Securely tighten the four socket screws.
7. Install the rear wheels. Refer to Removing/Installing Rear Wheels on page 38.
FIGURE 8.8 Repositioning the Camber Tube Mounting Bracket Socket Screws

Reversing the Camber Tube Mounting Bracket Direction

NOTE: For this procedure, refer to FIGURE 8.9 on page 46.
1. Remove the rear wheels
2. Remove the four socket screws, washers, and locking washers that secure the two
camber tube mounting bracket to the camber tube supports.
3. Rotate the camber tube so that the camber tube mounting bracket faces the opposite
direction.
4. Align the desires mounting positions of the camber tube mounting brackets with the
opening of the camber tube supports.
5. Install the four socket screws, washers, and lock washers into the desired mounting
positions of both camber tube mounting brackets. Hand tighten.
6. Slide the camber bar forward or backward to adjust the wheelbase length to the
desired position. Securely tighten the four socket screws.
Part No 1148078
Camber Tube
Support
Washers
Socket Screws
Camber Tube
Mounting Bracket
Camber
Tube
45
SECTION 8—WHEELS
Crossfire™Series Wheelchairs