Adjusting The Mounting Bracket Width - Invacare POWER 9000 Owner's Operator And Maintenance Manual

3. Line up the mounting holes of the controller
mounting bracket with the mounting holes in the
two (2) half clamps.
4. Secure the controller mounting bracket to the
two (2) half clamps with the remaining two (2)
hex screws.
5. Slide the joystick mounting tube (tube) through
the bracket to the desired position.
6. Slide the adjustment lock over the end of the
tube and secure the adjustment lock to the tube
by turning the lever on the adjustment lock.
Arm Tube
(reference only)
Threaded
Hole Half
Clamp
Opened Hole
Half Clamp
Adjustment Lock
FIGURE 4 - INSTALLING THE MKIV RII
JOYSTICK ONTO THE WHEELCHAIR
ADJUSTING THE MOUNTING BRACKET
WIDTH (FIGURE 5)
1. Remove the two (2) hex screws, spacers and
locknuts that secure the MKIV RII controller
mounting plate (plate) to the controller mount-
ing bracket.
2. Refer to DETAIL "A" in FIGURE 5 to determine
the mounting holes in the controller mounting
bracket for the corresponding seat width of the
wheelchair.
3. Line up the upper mounting holes in the plate
with the mounting holes in the controller bracket
determined in STEP 2.
Joystick
Joystick
Mounting
Tube
Hex Screws
Joystick Mounting Bracket
4. Install the long two (2) hex screws through the
controller mounting bracket, spacers, plate and
controller mounting bracket and securely tighten
with the two (2) locknuts.
Controller
Mounting
Bracket
Locknut
Battery Leads
Left/Right
Motor Leads
DETAIL "A"
14-INCH
SEAT WIDTH
16-INCH
SEAT WIDTH
18-INCH
SEAT WIDTH
20-INCH
SEAT WIDTH
FIGURE 5 - ADJUSTING THE MOUNTING
BRACKET WIDTH
22
Locknut
Spacer
MKIV RII
Controller
Long
Hex
Screw