Table of Contents
Advertisement
Printed Results
Faint or blurred printing
Grey background.
Dirt on the top edge or back of the paper
Characters out of position.
Corrective Action
Check the EcoPrint setting. (See
Check the EcoPrint setting.
Check the EcoPrint setting.
Check the EcoPrint setting.
When this setting is On, switch it to Off on the Remote
Operation Panel. (See
Confirm the
Confirm the
(toner) indicator.
(toner) indicator.
Confirm the
Confirm the
(toner) indicator.
(toner) indicator.
If the
(toner) indicator flashes, install a new toner
Chapter 3
Chapter 3
kit. (See
Chapter 3
Chapter 3
)
Clean the charger wire.
Clean the charger wire.
Clean the charger wire.
Clean the charger wire.
Open the printer's top and front covers. Remove the
process unit from the printer and slide the charger knob
back and forth to clean the charger wire.
Chapter 3
Chapter 3
(See
Chapter 3
Chapter 3
)
Try setting the thin paper mode.
Try setting the thin paper mode.
Try setting the thin paper mode.
Try setting the thin paper mode.
Set the paper type to Thin in the Remote Operation
Chapter 1
Chapter 1
Chapter 1
Chapter 1
Panel utility. (See
Check the operator panel.
Check the operator panel.
Check the operator panel.
Check the operator panel.
When the
(toner) indicator flashes, install a new
Chapter 3
Chapter 3
Chapter 3
Chapter 3
toner kit. (See
Check the process unit.
Check the process unit.
Check the process unit.
Check the process unit.
Open the printer's top cover and front cover, then check
that the process unit is properly installed.
Check the transfer roller.
Check the transfer roller.
Check the transfer roller.
Check the transfer roller.
Open the printer's top and front covers. Remove the
process unit from the printer and check whether the
transfer roller is dirty. If so, print several pages to
eliminate the dirt.
Check the registration roller.
Check the registration roller.
Check the registration roller.
Check the registration roller.
Open the printer's top and front covers. Remove the
process unit from the printer and check whether the
registration roller is soiled with toner. If so, wipe it clean
using the supplied wiper cloth.
Check the file or program.
Check the file or program.
Check the file or program.
Check the file or program.
Check whether the problem is being caused by a
PRESCRIBE command error. If the problem occurs only
with a specific file or program, the most likely cause is an
error in a parameter to a command or command syntax.
Check the paper size setting.
Check the paper size setting.
Check the paper size setting.
Check the paper size setting.
Check that the paper size set in the paper source and the
paper size set on the Remote Operation Panel are the
same. (See section
1.4.4
1.4.4 Paper Size
1.4.4
1.4.4
Chapter 5
Chapter 5
Chapter 5
Chapter 5
)
4-4
Print Quality Problems
Chapter 1
Chapter 1
Chapter 1
Chapter 1
)
Chapter 1
Chapter 1
Chapter 1
Chapter 1
)
)
)
Paper Size
Paper Size
Paper Size
on page
1-20
1-20
1-20
1-20
and
Advertisement
Table of Contents
