Log Placement - Monessen Hearth 6000DV Installation And Operating Instructions Manual

6000DV Gas Fireplace
Before you begin — This unit is supplied with eight ceramic fiber logs. Do not handle these logs
with your bare hands. always wear gloves to prevent skin irritation from ceramic fibers. After
handling the logs, wash your hands gently with soap and water to remove any traces of fibers.
the positioning of the logs is critical to the safe and clean
operation of this heater. excessive sooting and other problems
may result if the logs are not properly and firmly positioned in the
appliance. never add additional logs or embellishments such as
pine cones or vermiculite to the heater. only use the logs supplied
with the unit.
Failure to position the parts in accordance with diagrams below or
to use only parts specifically approved for this heater may result
in property damage or personal injury.
Install loGs and rocK wool (eMBer MaterIal) In FIreBox
1. Remove glass frame. Refer to Glass Frame Removal, Page 33.
2. Carefully remove logs from wrapping.
3. Place left log (#1) on left end of grate. Line up two (2) pin holes in bottom of log with two (2) pins
on grate. Log #1 will always be to the left of the control panel. Figure 40
4. Place right log (#2) on right end of grate. Line up three (3) pin holes in bottom of log with three
(3) pins on grate. Figure 41
Left Log
(#1)
Pins
Figure 40 -
Install Left Log (#1)
LG638
DV6000 left log
34
Grate
LG638
Control Panel
Figure 41 -
Install Right Log (#2)

loG placeMent

Right Log
(#2)
Control Panel
42D0200
LG639
Pins