SECTION 8—FRONT CASTERS
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.
Adjusting Front Caster Height
Make sure both front casters are the same size and are installed into the same
respective mounting hole before using the wheelchair. Otherwise, injury may occur.
NOTE: For this procedure, refer to FIGURE 8.1.
1. Remove the hex screw, washers and locknut that secure the front caster to the fork.
2. To reinstall the new front caster onto the fork, reverse STEP 1.
NOTE: Adjustable height
fork shown.
Part No. 1130169
WARNING
WARNING
Fork
Hex
Screw
FIGURE 8.1 Adjusting Front Caster Height
SECTION 8—FRONT CASTERS
Locknut
Front
Caster
27
Atlas™