Installing/Removing Seat Board; Adjusting Seat Angle - Invacare User guide User Manual

8.5 Installing / Removing Seat board
WARNING
• This adjustment should only be performed when the wheelchair is unoccupied.
• Take care not to damage any accessories fitted to the seat board.
The seat board can be removed from the wheelchair seat frame.
1. Remove the seat cushion (see section 8.1).
2. Remove the four fixing screws using a cross point screwdriver.
3. Install / Remove the seat board (if installing ensure that the holes on the under side of the seat
board are alligned with the slots in the seat frame).
4. Replace and tighten the four fixing screws using a cross point screwdriver.
NOTE:
Ensure the seat board is firmly secured before fitting the cushion or using the wheelchair.
8.6

Adjusting Seat Angle

WARNING
• This adjustment should only be performed when the wheelchair is on a flat, and horizontal
surace. Under no circumstances should this adjustment be made while the chair is in motion,
obstical climbing or stionary on a slope.
58