Replacing Plunger Release Knob; Removing/Installing The Side Panel; Removing Side Panels; Installing Side Panel - Invacare Deluxe Three-Position IH6065 series Operation And Maintenance Manual

SECTION 5—MAINTENANCE

Replacing Plunger Release Knob

NOTE: For this procedure, refer to FIGURE 5.10
1. Remove glide from end of frame.
2. Remove retaining ring from end of plunger pin.
3. Slide plunger release knob off the plunger pin.
4. Lift plunger pin and spring out of the
frame tube.
5. Insert new plunger pin and spring into
the frame so that grooved end of pin
extends below the frame tube.
6. Place plunger release knob over the
plunger pin.
7. Snap the retaining ring into groove of
the plunger pin.
8. Replace the glide into the end of the
frame.

Removing/Installing the Side Panel

NOTE: For this procedure, refer to FIGURE 5.11.

Removing Side Panels

1. Press the push buttons near the bottom of the right side panel.
2. Hold the push buttons in while pulling the panel outward.
3. Repeat STEPS 1 and 2 for the other side
panel.

Installing Side Panel

1. Slip the top of the right side panel into
the mounting tab.
2. Push the side panel upward until the
side panel fit into the side frame.
3. Pop the side panel into position when
the push buttons are visible, through
the push pin holes, near the bottom of
the side frame.
Invacare Mobile Recliners
Plunger Pin
Spring
Glide
Plunger Release Knob
Retaining Ring
FIGURE 5.10 Replacing Plunger Release
Push Buttons
FIGURE 5.11 Removing/Installing the Side
28
Frame
Plastic
Keeper
Frame Tube
Knob
Side
Panel
Panel
Part No. 1141494