Safety Agency Compliance Statements; Safety Precautions; Noise Level - Fujitsu SPARC Enterprise M3000 Safety And Compliance Manual

Safety Agency Compliance
Statements
English

Safety Agency Compliance Statements

Read this section before beginning any procedure. The
following text provides safety precautions to follow when
installing a Fujitsu product.

Safety Precautions

For your protection, observe the following safety
precautions when setting up your equipment:
Follow all cautions and instructions marked on the
■
equipment.
■ Ensure that the voltage and frequency of your power
source match the voltage and frequency inscribed on
the equipment's electrical rating label.
Never push objects of any kind through openings in
■
the equipment. Dangerous voltages may be present.
Conductive foreign objects could produce a short
circuit that could cause fire, electric shock, or damage
to your equipment.
Symbols
The following symbols may appear in this book:
Caution – There is a risk of personal injury
and equipment damage. Follow the
instructions.
Caution – Hot surface. Avoid contact.
Surfaces are hot and may cause personal
injury if touched.
Caution – Hazardous voltages are present. To
reduce the risk of electric shock and danger to
personal health, follow the instructions.
Depending on the type of power switch your device has,
one of the following symbols may be used:
On – Applies AC power to the system.
Off – Removes AC power from the system.
Standby – The On/Standby switch is in the
standby position.
Modifications to Equipment
Do not make mechanical or electrical modifications to the
equipment. Fujitsu is not responsible for regulatory
compliance of a modified Fujitsu product.
Placement of a Fujitsu Product
Caution – Do not block or cover the openings
of your Fujitsu product. Never place a Fujitsu
product near a radiator or heat register.
Failure to follow these guidelines can cause
overheating and affect the reliability of your
Fujitsu product.

Noise Level

Product: SPARC Enterprise M3000 Server
Declared Noise emissions in accordance with ISO 7779
LWAd (1B=10dB)
1
LpAm
1 Above are measured values when the product is mounted to the
lowest part of the rack. Noise that you actually hear differs
depending on where you are.
Operating Idling
6.6 B 6.6 B
47 dB 47 dB
9