Optional Wall Command Center - Monessen Hearth WDV Wideview WDV500 Installation And Operating Instructions For

sIGnature cOMManD OptIOnal Wall cOMManD center and BlOWer systeM
WDV Series Gas Fireplace
Electrical connections should only be
performed by a qualified, licensed electri-
cian. Main power supply must be turned
off before performing service.
Only a qualified service person should
service and repair the fireplace. A quali-
fied service person should connect and
disconnect the fireplace to gas supply.
Follow all local codes.
Figure 32 -
Signature Command Wiring Diagram
cOMManD center Wall InstallatIOn
The Command Center may be mounted on the wall with the use of the SCSWEK Kit. (15' cable,
junction box and wall cover).
Mount the junction box provided at the desired location on the wall. Do not extend beyond the 15'
wire cable provided.
Route wire from junction box to lower control area at bottom of fireplace. Unplug the 1' cable from
control box and command center. Plug the 15' extension cable into the control box. Remove com-
mand center from the fireplace and plug the other end of the extension cable into the command
center. Snap on wall cover provided and screw to junction box.
4
TO JUNCTION BOX
IN FIREPLACE
WHITE
BLACK
WHITE
Opt. Blower
BLACK
BLACK
Opt. Aux.
WHITE
GREEN
fp2140
Signature command wiring
A/C BOX
CONTROL BOX
CONVERSION
NG/LP
PLUG IN CONNECTOR
CONTROL BOX TO COMMAND CENTER
PLUG IN CONNECTOR
STEPPER MOTOR TO
CONTROL BOX
GROUND
DC POWER/GREEN
PLUG IN CONNECTOR
CONTROL BOX TO
SOLENOID
GAS IN
VALVE
PILOT
RF RECEIVER
ON/OFF BUTTON
BLACK/THERMOPILE
RED/THERMOPILE
SENSING
IGNITER/SPARKER
OFF/LO
MASTER
ON/HI
SWTICH
LED
4-AA BATTERY
COMPARTMENT
COMMAND
CENTER
GAS OUT
PILOT GAS TUBING
78D0011