Operating Instructions - Gateway FPD1700 Service Manual

FRONT VIEW
Power ON/OFF Button
Power (DPMS) Indicator
SOURCE Button
1. SOURCE Button
• Use this button to make Dsub or DVI connector
active. This feature is used when two computers are
connected to the monitor. The default setting is Dsub.
2. MENU Button
Use this button to enter or exit the on screen display.
3.
Button
Use these buttons to choose or adjust items in the on
screen display
<Shortcut Keys>
• Brightness and Contrast can be
adjusted directly without entering the
On Screen Display (OSD) system.
100
Touch the
100
the settings and then the OSD button
to save all changes. The Brightness
and Contrast functions are also
available in the On Screen Display
(OSD) menu.

OPERATING INSTRUCTIONS

AUDIO DC OUT
Front Control Panel
MENU Button
SOURCE MENU
buttons to adjust
REAR VIEW
D
DVI port
D-Sub Signal Port
AUTO/SET Button
Button
Power Button
AUTO/SET
4. AUTO/SET Button
Use this button to enter a selection in the on screen
display.
* AUTO adjustment function
TO the AUTO/SET button before
using OSD menu. This button is
for the automatic adjustment of the screen position, clock
and phase.
Note: Some signal from some graphics boards may not
function properly. If the results are unsatisfactory, adjust
your monitor's Position, Clock and Phase manually.
5. MENU, Button
Press the hold the MENU button and
button for 3 seconds: the message
"CONTROLS LOCKED" appears.
You can unlock the OSD controls
at any time by pushing the MENU,
button for 3 seconds:
the message "CONTROLS UNLOCKED" will appear.
Power Connector
Power Indicator
P R O C E S S I N G
A U T O C O N F I G U R A T I O N
CONTROLS LOCKED
CONTROLS UNLOCKED