Yamaha MCR-E810 Service Manual page 29

3. Command Communication for System Function
3.1 Power on
(1) Power on by RX "STANDBY/ON" key operation
RX turns on the power by RX's "STANDBY/ON" key and at the same time DVD also turns on the power if DVD
state is power on at the last RX's power on.
RX "STANDBY/ON" key
operation
* RX transmits POWER_ON command if DVD state at the last RX' s power on is power on.
(2) Power on of individual unit by each "STANDBY/ON" key operation
In the system power on, the each unit can be changed into standby and then into power on again by the
"STANDBY/ON" key operation of the unit.
When the power supply of the unit is individually supplied, only the unit can turn on the power by operating
"STANDBY/ON" key of an individual unit even in system standby.
DVD "STANDBY/ON"
key operation
RX unit
[Standby state]
Power on process
Power supply through AC OUTLET
PORT_PRE_STANDBY
PORT_STANDBY
POWER_ON command if necessary *
PORT_STOP
RX unit
PORT_STOP
DVD unit
[Power shut down]
Reset start
initialize process
Initialize complete
Power on process
DVD unit
[Standby state]
Power on process
DVD-E810
29