Settings; Settings Menu - Pfaff Ambition line Owner's Manual

Settings

In the settings menu, you can adjust the machine
settings and screen settings. All settings are stored
even when the machine is turned off.

Settings menu (1.5)

Touch the settings menu tab (A) to open. The
settings menu is divided into two tabs. Select a tab
(1 or 2) by touching it.
Twin needle
Touch the twin needle icon to activate. Touch "-"
and "+" to set the twin needle width. The selected
width is shown in the twin needle icon.
When a twin needle size is selected, the width of
all stitches is limited for that needle size to prevent
needle breakage.
A warning pop-up will be shown if you select a
stitch that is too wide for the set twin needle size.
When activated, the twin needle icon will be
shown in sewing mode.
The setting is kept until you deactivate it.
Note: Twin needle and stitch width safety cannot be
used at the same time. A warning sound will be heard
when trying to activate both settings.
Stitch width safety
Select this function when using a straight stitch
needle plate or a straight stitch presser foot to lock
the center needle position for all stitches to prevent
damage to the needle, presser foot or stitch plate.
Touch the stitch width safety icon to activate.
When activated, the stitch width safety icon will
be shown in sewing mode.
The setting is kept until you deactivate it.
Note: When turning on the machine with this setting
activated and for every stitch selection that is not a
straight stitch, a pop-up informs you that the machine is
set for straight stitch.
Twin needle and stitch width safety cannot be used at
the same time. A warning sound will be heard when
trying to activate both settings.
Contrast
Touch "-" and "+" to adjust the contrast of the
touch screen. The setting is stored even when the
machine is turned off.
2:14
ambition™ 1.5
Touch screen calibration
When touching the icons on the screen, the screen
might need a calibration to adjust to your touch.
Touch the calibration icon to open a special view
for touch screen calibration. Use the stylus to
fi rst touch the center of the cross in the top left
corner, then touch the center of the cross in the
bottom right corner. The calibration view closes
automatically when you have touched the second
cross.
Language
Touch "-" and "+" to change the language of all
text in your machine.
Software version
Check the software version for your sewing
machine.
A