Something Not Working - Zanussi Electrolux ZDF 501 User Manual

Something not working

IMPORTANT!
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be solved
with the help of the indications described in the chart, without calling out an engineer.
Open the door and carry out the following suggested corrective actions.
IMPORTANT!
When carrying out the suggested corrective
actions the appliance must be switched off.
Fault code / malfunction
The dishwasher does not fill with
water.
- continuous flashing of the
light of the running programme
- appears in the digital
display
The dishwasher will not drain.
- continuous flashing of the
light of the running programme
- appears in the digital
display
- continuous flashing of the
light of the running programme
- appears in the digital
display
The programme does not start.
Possible cause
The water tap is blocked or furred
with limescale.
The water tap is turned off.
The filter (where present) in the .
threaded hose fitting at the water
inlet valve is blocked.
The water inlet hose has not been
correctly laid or it is bent or
squashed.
The sink spigot is blocked.
The water drain hose has not been
correctly laid or it is bent or
squashed.
Anti-flood device is activated.
The dishwasher door has not been
properly closed.
The main plug is not plugged in.
The fuse has blown in the household Replace the fuse.
fuse box.
Delay start has been selected
Solution
Clean the water tap.
Turn the water tap on.
Clean the filter in the.
threaded hose fitting.
Check the water inlet hose
connection.
Clean out the sink spigot.
Check the water drain hose
connection.
Close the water tap and
contact your local Service
Force Centre.
Close the door
Insert the mains plug
If dishes are to be washed
immediately, cancel the delay
start.
19