Led Error Display; Updates Of The Sparc Enterprise M8000/M9000 Servers Site Planning Guide; Cooling (Air-Conditioning) Requirements - Fujitsu SPARC Enterprise M8000 Product Notes

LED Error Display

The following content will be added to the SPARC Enterprise M8000/M9000 Servers
Service Manual., Section 2.6, "LED Error Display," TABLE 2-11 Status Display of LEDs
Defined Individually for Each FRU.
Status Display of LEDs Defined Individually for Each FRU
TABLE 4
FRU LED
Type
HDD READY
OK
CHECK
Updates of the SPARC Enterprise M8000/M9000
Servers Site Planning Guide
The following information supersedes the information in the SPARC Enterprise
M8000/M9000 Servers Site Planning Guide.

Cooling (Air-Conditioning) Requirements

This is to correct the description in the SPARC Enterprise M8000/M9000 Servers Site
Planning Guide, Section 2.3.1, "Cooling (Air-Conditioning) Requirements."
Meaning
Display
Lit (green) Indicates that the HDD is in operation. In this state, the HDD cannot be
removed (cannot be replaced).
Blinking Indicates that the HDD is being accessed. In this state, the HDD cannot
(green) be removed (cannot be replaced).
Off Indicates that the HDD can be replaced.
Lit (amber) Indicates that an error was detected in the HDD. However, this LED
remains on for a few minutes immediately after power-on (until the
start of initialization). It does not indicate an error during that time.
Blinking Indicates that the HDD is a replacement target.
(amber)
Off Indicates that the HDD is in the normal state.
SPARC Enterprise M8000/M9000 Servers Product Notes 15