Changing The Battery - Boss AW-3 Dynamic Wah Owner's Manual

Changing the Battery

When the CH
ECK indicator goes dim or no
longer lights while an effect is on, it means
that the battery is nearly dead and must be
Replace the battery following
replaced.
the steps below.
* For best results (i.e.., longest usable life)
use an alkaline type battery.
Thumbscrew
Battery Snap
Cord
Battery
Snap
9V Battery
18
Pedal
Spring Base
Coil Spring
Guide Bush
Hole
Battery Housing
1. Loosen the thumbscrew at the front of
the pedal, then lift the pedal upwards to
open the unit.
* The thumbscrew can be left in the pedal
while changing the battery.
2. Remove the old battery from the battery
housing, and remove the battery snap
connected to it.
3. Connect the battery snap to the new bat-
tery, and place the battery inside the bat-
tery housing.
* Be sure to carefully observe the battery's
polarity (+ versus -).
4. Slip the coil spring onto the spring base on
the back of the pedal, then close the pedal.
* Take care not to allow the battery snap cord to become
caught in the pedal, coil spring, or other places.
5. Finally, insert the thumbscrew into the
guide bush hole and fasten it securely.